Allied Telesis AT-S63 User Manual
Stack command line interface user’s guide, Management software
Table of contents
Document Outline
- Contents
- Tables
- Preface
- Section I
- Basic Operations
- Chapter 1
- Overview
- Introduction
- AT-S63 Management Software
- Supported Models
- Supported Features
- AT-StackXG Stacking Module
- Maximum Number of Switches in a Stack
- Management Interfaces
- Management Access Methods
- Enhanced Stacking
- Stack Topology
- Discovery Process
- Master and Member Switches
- Active Configuration File
- Module ID Numbers
- Port Numbers in Commands
- MAC Address Tables
- File Systems
- Compact Flash Memory Card Slots
- Stack IP Address
- Upgrading the AT-S63 Management Software
- SNMP
- Powering On a Stack
- Troubleshooting the Discovery Process
- Chapter 2
- Starting a Command Line Management Session
- Chapter 3
- Basic Command Line Commands
- Chapter 4
- Stacking Commands
- Chapter 5
- Basic Stack Commands
- Chapter 6
- Port Parameter Commands
- Chapter 7
- Port Statistics Commands
- Chapter 8
- MAC Address Table Commands
- Chapter 9
- Static Port Trunking Commands
- Chapter 10
- Port Mirroring Commands
- Section II
- Advanced Operations
- Chapter 11
- File System Commands
- Chapter 12
- File Download and Upload Commands
- Chapter 13
- Event Log and Syslog Client Commands
- Chapter 14
- Class of Service (CoS) Commands
- Section III
- Spanning Tree Protocols
- Chapter 15
- Spanning Tree Protocol Commands
- Chapter 16
- Rapid Spanning Tree Protocols Commands
- Section IV
- Virtual LANs
- Chapter 17
- Port-based and Tagged VLAN Commands
- Section V
- Internet Protocol Routing
- Chapter 18
- Routing Interface Commands
- Index