Allied Telesis AT-S63 - Manual (Page 91)

AT-S63 Stack Command Line Interface User’s Guide
Section I: Basic Operations 91
SHOW ASYN
Syntax
show asyn
Parameters
None.
Description
This command displays the settings for the serial terminal port on the
master switch. The port is used for local management of the stack. An
example of the display is shown in Figure 11.
Figure 11. SHOW ASYN Command
To configure the serial port’s baud rate, refer to “SET ASYN” on page 82.
To configure the command line prompt, refer to “SET PROMPT” on
page 65. You cannot adjust the parity, data bits, or stop bit of the serial
terminal port.
Example
The following command displays the serial terminal port settings:
show asyn
Asynchronous Port (Console) Information:
Baud Rate ................................. 115200
Parity .................................... NONE
Data bits ................................. 8
Stop bits ................................. 1
Prompt .................................... "AN7 Stack"