Allied Telesis AT-S63 - Manual (Page 191)

AT-S63 Stack Command Line Interface User’s Guide
Section II: Advanced Operations 191
UPLOAD METHOD=TFTP
Syntax
upload method=tftp destfile= filename server= ipaddress
srcfile|file=switchcfg|[cflash:] filename |appblock
Parameters
method Specifies a TFTP upload.
destfile Specifies a filename for the uploaded file. This is the
name given the file when it is stored on the TFTP server.
If the name contains spaces, enclose it in quotes.
server Specifies the IP address of the network node containing
the TFTP server software.
srcfile or file Specifies the file to be uploaded. Options are:
switchcfg Uploads the switch’s active boot
configuration file.
filename Uploads a file from the switch’s file
system. If the file is stored on a compact
flash card, precede the name with
“cflash:”.
appblock Uploads the switch’s active AT-S63
image file.
Description
A TFTP upload uses the TFTP client software on the switch to upload files
from the file system on the system to a TFTP server on the network. You
can use the command to upload a switch’s active boot configuration file or
any other file from the file system, such as an SSL certificate enrollment
request or a public encryption key. This command can also upload a file
from a compact flash memory card in the switch to a TFTP server. You
can also use the command to upload the switch’s active AT-S63 software
image from the application block to a TFTP server, though it is unlikely you
would ever have need for that function.
When performing a TFTP upload, note the following:
ˆ A TFTP upload is supported from a local, Telnet, or SSH management
session.
ˆ There must be a node on your network that contains the TFTP server
software. The uploaded file will be stored on the server.