Allied Telesis AT-S63 - Manual (Page 110)

Chapter 6: Port Parameter Commands
110 Section I: Basic Operations
backpressure Controls backpressure on the port.
Backpressure applies only to ports operating in
half-duplex mode. The options are:
yes, on, true, enabled Activates backpressure
on the port. These
options are equivalent.
no, off, false, disabled Deactivates
backpressure on the
port. This is the default.
These options are
equivalent.
bplimit Specifies the number of cells for back pressure.
A cell represents 128 bytes. The range is 1 to
7935 cells. The default value is 7935 cells.
holbplimit Specifies the threshold at which the stack
signals a head of line blocking event on a port.
The threshold is specified in cells. A cell is 128
bytes. The range is 1 to 61,440 cells; the default
is 7,168.
renegotiation Prompts the port to renegotiate its speed and
duplex mode with the end node. This parameter
only works when the port is using Auto-
Negotiation. The only option is:
auto Renegotiates speed and duplex
mode with the end node.
softreset Resets the port. This parameter does not
change any of a port’s operating parameters.
Description
This command configures the operating parameters of a port. You can set
more than one parameter at a time.
Examples
The following command disables ports 4.1 to 4.6:
set switch port=4.1-4.6 status=disabled
The following command configures port 3.8 to operate at 10 Mbps, half
duplex:
set switch port=3.8 speed=10mhalf