Allied Telesis AT-S63 - Manual (Page 255)

AT-S63 Stack Command Line Interface User’s Guide
Section III: Spanning Tree Protocols 255
ptp or Defines whether the port is functioning as a point-
pointtopoint to-point port. The parameters are equivalent. This type
of port is connected to a device operating at full-duplex
mode. The options are:
yes, on, true The port is an point-to-point port. The
options are equivalent.
no, off, false The port is not an point-to-point port.
The parameters are equivalent. are
equivalent.
autoupdate The port’s status is determined
automatically. This is the default.
migrationcheck Enables and disables migration check. The purpose of
this feature is to change from the RSTP mode to the
STP mode if STP BDPU packets are received on the
selected port. When you enable this option, the bridge
will send out RSTP BPDU packets from the selected
port until STP BPDU packets are received. The port will
remain in the RSTP mode until it receives an STP
BPDU packet. The options are:
yes, on, true Enable migration check. The options
are equivalent.
no, off, false Disable migration check. The options
are equivalent.
Description
This command sets a port’s RSTP settings.
Examples
This command sets the port cost to 1,000,000 and port priority to 224
(increment 14) on port 2.4:
set rstp port=2.4 portcost=1000000 portpriority=14
This command specifies ports 1.6 to 1.8 as not edge ports:
set rstp port=1.6-1.8 edgeport=no