Allied Telesis AT-S63 - Manual (Page 88)

Chapter 5: Basic Stack Commands
88 Section I: Basic Operations
SET TELNET INSERTNULL
Syntax
set telnet insertnull=on|off
Parameters
insertnull Controls whether the Telnet server inserts a NULL character
after each CR sent to the remote client. Options are:
on Sends a NULL character after each CR sent to the
remote client.
off Specifies that no NULL character is sent to the
remote client. This is the default setting.
Description
You can use this command to toggle the Telnet server on the master
switch to add a NULL character after each CR for those Telnet clients that
require the character in order to display the information correctly. The
default setting on the master switch is to not send the NULL character
after a CR. To view the current setting, see “SHOW SWITCH” on page 95.
Example
This command configures the master switch to send a NULL character
after each CR during a Telnet management session:
set telnet insertnull=on