Allied Telesis AT-S63 - Manual (Page 293)

AT-S63 Stack Command Line Interface User’s Guide
Section V: Internet Protocol Routing 293
SHOW IP COUNTER
Syntax
show ip counter [port= ports |all]
Parameters
port Specifies the ports whose IP statistics are to be
displayed. Port numbers are specified in the following
format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command displays Layer 3 counters for the individual ports on a
stack. Figure 35 is an example of the information displayed by this
command.
Figure 35. SHOW IP COUNTER Command
The lines in the display are:
ˆ IPInUcastPkts - Number of IP packets received on a port.
ˆ IPOutUcastPkts - Number of IP packets transmitted from a port.
ˆ IPInDiscards - Number of IP packets received but discarded due to
resource limitations at the IP level.
ˆ IPInHdrErrors - Number of IP packets received with header errors.
Port 1.1
IPInUcastPkts ................... 0
IPOutUcastPkts .................. 0
IPInDiscards .................... 0
IPInHdrErrors ................... 0
Port 1.2
IPInUcastPkts ................... 0
IPOutUcastPkts .................. 0
IPInDiscards .................... 0
IPInHdrErrors ................... 0