Allied Telesis AT-S63 - Manual (Page 82)

Chapter 5: Basic Stack Commands
82 Section I: Basic Operations
SET ASYN
Syntax
set asyn [speed=1200|2400|4800|9600|19200|38400|
57600|115200] [prompt=”
prompt ”]
Parameters
speed Sets the speed (baud rate) of the serial terminal port
on the master switch. The default is 9600 bps.
prompt Specifies the command line prompt. The prompt can
be from one to 12 alphanumeric characters. Spaces
and special characters are allowed. The prompt must
be enclosed in double quotes. This parameter
performs the same function as “SET PROMPT” on
page 65.
Description
This command sets the baud rate of the serial terminal port on the master
switch of the stack. The port is used for local management. You can also
use this command to set the command line prompt.
Note
A change to the baud rate of the port ends your management
session if you are managing the stack locally. To reestablish a local
management session you must change the speed of the terminal or
the terminal emulator program to match the new speed of the serial
terminal port on the master switch.
Example
The following command sets the baud rate to 115200 bps:
set asyn speed=115200
Equivalent Command
set prompt=" prompt "
For information, see “SET PROMPT” on page 65.