Allied Telesis AT-S63 - Manual (Page 267)

AT-S63 Stack Command Line Interface User’s Guide
Section IV: Virtual LANs 267
DELETE VLAN
Syntax 1
delete vlan= name [vid= vid ] ports= ports frame=untagged|tagged
Syntax 2
delete vlan= name [vid= vid ] taggedports= ports
untaggedports= ports
Parameters
vlan Specifies the name of the VLAN to be modified.
vid Specifies the VID of the VLAN to be modified. This
parameter is optional.
ports Specifies the ports to be removed from the VLAN.
This parameter must be used with the FRAME
parameter. Port numbers are specified in the
following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
frame Identifies the ports to be removed as tagged or
untagged. This parameter must be used with the
PORT parameter.
taggedports Specifies the tagged ports to be removed from the
VLAN.
untaggedports Specifies the untagged ports to be removed from the
VLAN.
Description
This command removes tagged and untagged ports from a port-based or
tagged VLAN.
This command has two syntaxes. You can use either command to delete
ports from a VLAN. The difference between the two is that Syntax 1 can
remove only one type of port, tagged or untagged, at a time from a VLAN,
while Syntax 2 allows you to remove both port types in the same
command. This is illustrated in the Examples section below.