Allied Telesis AT-S63 - Manual (Page 11)

11
Preface
This guide explains how to configure the operating parameters of the
AT-9400 Basic Layer 3 Gigabit Ethernet Switches when the units are
installed as a stack with the AT-StackXG Stacking Module.
Note
A stack does not support all the features of the AT-S63 Management
Software. For information, refer to “Supported Features” on page 26.
Note
A stack must be managed from the command line interface. The
menus interface and the web browser interface are not supported in
a stack.
This Preface contains the following sections:
ˆ “How This Guide is Organized” on page 13
ˆ “Product Documentation” on page 14
ˆ “Where to Go First” on page 15
ˆ “Starting a Management Session” on page 16
ˆ “Document Conventions” on page 17
ˆ “Where to Find Web-based Guides” on page 18
ˆ “Contacting Allied Telesis” on page 19