Allied Telesis AT-S63 - Manual (Page 146)

Chapter 9: Static Port Trunking Commands
146 Section I: Basic Operations
CREATE SWITCH TRUNK
Syntax
create switch trunk= name port= ports
[select=macsrc|macdest|macboth|ipsrc|ipdest|ipboth]
Parameters
trunk Specifies the name of the trunk. The name can be up to
16 alphanumeric characters. No spaces or special
characters are allowed.
port Specifies the ports to be added to the port trunk. Port
numbers are specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 40.
select Specifies the load distribution method. Options are:
macsrc Source MAC address.
macdest Destination MAC address.
macboth Source address/destination MAC
address.
ipsrc Source IP address.
ipdest Destination IP address.
ipboth Source address/destination IP
address.
Description
This command creates a static port trunk. To create the trunk, you specify
the stack ports and the load distribution method. For an explanation of the
load distribution methods, refer to the AT-S63 Management Software
Features Guide.