Allied Telesis AT-S63 - Manual (Page 212)

Chapter 13: Event Log and Syslog Client Commands
212 Section II: Advanced Operations
SET LOG FULLACTION
Syntax
set log fullaction [temporary=halt|wrap]
[permanent=halt|wrap]
Parameters
fullaction Specifies what happens when a log reaches
maximum capacity. You can set the action separately
for each log. The possible actions are:
halt The log stops storing new events.
wrap The log deletes the oldest entries as new
ones are added. This is the default.
Description
This command defines the action of an event log when it has stored its
maximum number of entries. The HALT option instructs the log to stop
storing new entries. If the event log has already reached its maximum
capacity, it immediately stops entering new entries. The WRAP option
instructs the log to delete the oldest entries as new entries are added.
To view the current actions of the event logs, refer to “SHOW LOG
OUTPUT” on page 221.
Example
The following command configures the event log in permanent memory to
stop storing new entries after it has stored the maximum number of
allowed entries:
set log fullaction permanent=halt