Allied Telesis AT-S63 - Manual (Page 112)

Chapter 6: Port Parameter Commands
112 Section I: Basic Operations
SET SWITCH PORT FILTERING
Syntax
set switch port= port
[bcastfiltering=yes|no|on|off|true|false|enabled|
disabled]
[bcastegressfiltering=yes|no|on|off|true|false|enabled|
disabled]
[unkmcastfiltering=yes|no|on|off|true|false]
[unkmcastegressfiltering=yes|no|on|off|true|false]
[unkucastfiltering=yes|no|on|off|true|false]
[unkucastegressfiltering=yes|no|on|off|true|false]
Parameters
port Specifies the port you want to configure. You
can specify more than one port at a time. Port
numbers are entered in the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
bcastfiltering Controls the ingress broadcast frame filter. The
options are:
yes, on, true, enabled The port discards all
ingress broadcast
frames. These options
are equivalent.
no, off, false, disabled The port forwards all
ingress broadcast
frames. This is the
default. These options
are equivalent.
bcastegressfiltering Controls the egress broadcast frame filter. The
options are:
yes, on, true, enabled The port discards all
egress broadcast
frames. These options
are equivalent.
no, off, false, disabled The port forwards all
egress broadcast
frames. This is the
default. These options
are equivalent.