Allied Telesis AT-S63 - Manual (Page 262)

Chapter 17: Port-based and Tagged VLAN Commands
262 Section IV: Virtual LANs
ADD VLAN
Syntax 1
add vlan= name [vid= vid ] ports= ports |all
frame=untagged|tagged
Syntax 2
add vlan= name [vid= vid ] taggedports= ports |all
untaggedports= ports |all
Parameters
vlan Specifies the name of the VLAN to modify.
vid Specifies the VID of the VLAN you want to modify. This
parameter is optional.
ports Specifies the ports to be added to the VLAN. Port
numbers are entered in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 40.
frame Identifies the new ports as either tagged or untagged.
This parameter must be used with the PORTS
parameter.
taggedports Specifies the ports to be added as tagged ports to the
VLAN. To include all ports on the stack as tagged ports
in the VLAN, use ALL.
untaggedports Specifies the ports to be added as untagged ports to
the VLAN. Specifying ALL adds all ports on the stack
as untagged ports to the VLAN.
Description
This command adds tagged and untagged ports to an existing port-based
or tagged VLAN.
Note
To initially create a VLAN, see “CREATE VLAN” on page 264. To
remove ports from a VLAN, see “DELETE VLAN” on page 267.