Allied Telesis AT-S63 - Manual (Page 156)

Chapter 10: Port Mirroring Commands
156 Section I: Basic Operations
SET SWITCH PORT MIRROR
Syntax
set switch port= port mirror=none|rx|tx|both
Parameters
port Specifies the source port of a port mirror. You can
specify more than one port. Port numbers are specified
in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 40.
mirror Specifies which traffic on the source ports is to be
mirrored to the destination port. The options are:
rx Specifies ingress mirroring.
tx Specifies egress mirroring.
both Specifies both ingress and egress mirroring.
none Removes a port as a source port.
Description
This command specifies the source ports of a port mirror. If the port mirror
already has source ports, the new source ports are added to the existing
ports. You can also use the command to remove source ports.
You must set the destination port before you can select the source ports.
To set the destination port, refer to “SET SWITCH MIRROR” on page 155.
Examples
This command specifies ports 1.16 and 1.17 as source ports of the port
mirror. The ingress traffic on the ports is copied to the destination port:
set switch port=1.16-1.17 mirror=rx
This command removes ports 2.5, 2.7, and 5.10 as source ports of a port
mirror:
set switch port=2.5,2.7,5.10 mirror=none