Allied Telesis AT-S63 - Manual (Page 174)

Chapter 11: File System Commands
174 Section II: Advanced Operations
SHOW CONFIG
Syntax
show config [dynamic]
Parameter
dynamic Displays the stack’s parameter settings in
command line format.
Description
This command, when used without the DYNAMIC parameter, displays two
pieces of information. An example is shown in Figure 22.
Figure 22. SHOW CONFIG Command
The “Boot configuration file” field displays the name of the file that the
master switch uses to store the parameter settings of the stack whenever
the SAVE CONFIGURATION command is issued. This is also the file that
the master switch will use during the reset or power cycle to configure the
stack. To change the boot configuration file, refer to “SET CONFIG” on
page 171.
The “Current Configuration” displays the name of the boot configuration
file that the master switch used to configure the stack during the last
discovery process.
The DYNAMIC parameter displays the parameter settings that have been
changed from their default value, in command line format. An example is
shown in Figure 12 on page 92.
Example
This command displays the names of the active and current configuration
files:
show config
This command displays the parameter settings of the stack in command
line format:
show config dynamic
Boot configuration file .............. "SalesSt4a.cfg" (Exists)
Current configuration ................ "SalesSt4a.cfg"