Allied Telesis AT-S63 - Manual (Page 253)

AT-S63 Stack Command Line Interface User’s Guide
Section III: Spanning Tree Protocols 253
SET RSTP PORT
Syntax
set rstp port= port [pathcost|portcost= cost |auto]
[portpriority= portpriority ]
[edgeport=yes|no|on|off|true|false]
[ptp|pointtopoint=yes|no|on|off|true|false|autoupdate]
[migrationcheck=yes|no|on|off|true|false]
Parameters
port Specifies the port you want to configure. You can
specify more than one port at a time. Port numbers are
specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 40.
pathcost or Specifies the port’s cost. The parameters are
portcost equivalent. The spanning tree algorithm uses the cost
parameter to decide which port provides the lowest cost
path to the root bridge for that LAN. The options are:
cost A number for the port cost. The range is
1to 200,000,000.
auto Automatically sets the port cost according
to the speed of the port. This is the default.
Table 15 lists the port cost with auto-
detect.
Table 15. RSTP Auto-Detect Port Costs
Port Speed Port Cost
10 Mbps 2,000,000
100 Mbps 200,000
1000 Mbps 20,000