Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGER - Manual (Page 17)

2.2.2 Starting From HP OpenView Network Node Manager
To start Device Manager from HP OpenView, select a node on the map window,
then select AlliedView-EMS > Device Manager from the Tools menu.
Note that Device Manager and HP OpenView run independently of each other,
so exiting HP OpenView has no effect on Device Manager. Device Manager
continues to run even after HP OpenView stops running. To exit Device
Manager, select Exit from its File menu.
Starting from HP OpenView
Note - The configuration of HP OpenView changes during the installation of
AlliedView-EMS to incorporate Device Manager and AMIGO in its menu.
Note - For the AT-AR255E running firmware v1.0.2, HP OpenView sets the host
name to “RIP2-ROUTERS.MCAST.NET”. Device Manager, when started within
HP OpenView, uses this host name and connects to any RIP2 router present in
the network. As a result, Device Manager may not load the AT-AR255E device
panel and may instead load another device’s image. To prevent this from
happening, create one entry in the local hosts file for each AT-AR255E running
AlliedView™-EMS 3.10 Device Manager User’s Guide Page 17 of 133