Apple Macintosh LC 630 DOS - Manual (Page 83)

Changing the size of the drive container
You may find, after installing software in a drive container, that the container
is too small or too large for your needs. You cannot change the size of an
existing drive container, but you can create a new one in the appropriate size
and move the software to it. You can also create an additional drive container
to supplement the existing one.
Two active containers maximum: For the following procedure to work,
drive D must be available for assignment to a new drive container. If both
drives C and D have been assigned, you must first set drive D to None and
drive C to the container you need to replace. (The contents of the container
mapped to drive D are unaffected.)
Calculating the proper size
To determine the proper size for the new container, follow these steps:
1 Make sure you’re in the Mac OS, then open the PC Setup control panel.
You see a small apple at the upper-left corner of the screen when you’re in the
Mac OS.
2 Check the name of the container associated with drive C.
The name of the container appears above the C: pop-up menu.
3 Locate the container in the Finder.
72 Chapter 6