Apple Macintosh LC 630 DOS - Manual (Page 180)

Installing NetManage’s Chameleon TCP/IP software
IMPORTANT You must not have MacTCP installed when you run DOS TCP/IP
software; the two will conflict with one another.
You can use the IPX and TCP protocols at the same time in either the PC
environment or the Mac OS, or you can use one protocol in the PC
environment and the other protocol in the Mac OS. However, you cannot use
the same protocol in both environments at the same time.
If you want to use the IPX protocol in the PC environment and you have
previously installed MacIPX in the Mac OS, remove MacIPX from the
Control Panels folder or select AppleTalk as your network interface in the
MacIPX control panel.
If you want to use the TCP protocol in the PC environment and you have
previously installed MacTCP in the Mac OS, remove MacTCP from the
Control Panels folder or select an interface other than Ethernet in the
MacTCP control panel.
You must have Windows installed before installing the Chameleon TCP/IP
software. If you need to reinstall Windows, see “Reinstalling PC Software” in
the section “Reinstalling the DOS-Compatibility Software” in Chapter 8.
In addition, you need to know the following information before you start:
m A legitimate, assigned IP address for the machine on which you’re
installing the TCP/IP software (for example, 222.111.11.1). For connecting to
the Internet, your service provider will tell you the correct address. For
TCP/IP networking within your company, your network administrator can
provide you with an address.
m The name of your domain name server (for example, server.edu).
m The IP address of your domain name server (for example, 111.222.0.0).
m The IP address of your Internet gateway, if any.
Once you have this information, you can proceed.
169 Installing Network Management Software