Apple Macintosh LC 630 DOS - Manual (Page 175)

Before you start, be sure you have the appropriate floppy disks for the version
of NetWare you wish to install.
In addition, you need to know the Ethernet frame type in use on your
network segment. You must choose the appropriate frame type in Step 11
below. If you are not certain which one to select, ask your network
administrator before you begin the installation.
1 Insert the Novell NetWare Client for DOS WSDOS_1 disk into the disk drive.
2 At the DOS prompt, type the following:
A:
INSTALL
3 The NetWare Client Install screen appears.
Follow the instructions, pressing Return for each selection.
4 Define the directory for NetWare.
The default is C:\NWCLIENT. Press Return once to confirm the entry and
press it again to execute this step.
5 Edit the CONFIG.SYS file.
Change your LASTDRIVE statement so that it reads LASTDRIVE=Z .
6 Add the following line to your AUTOEXEC.BAT file:
CALL C:\NWCLIENT\STARTNET.BAT
Press Y-Return.
7 Decide whether you wish to load the Windows support in the directory where you have
loaded Windows.
Press Y or N. If yes, press Return once to confirm the Windows subdirectory
entry and again to execute this step.
8 Select the driver for the network board. Press Return.
9 A message asks you to insert another disk. Follow the instructions on the screen.
10 In the dialog box, select Power Macintosh 6100 Ethernet Adapter and press Return.
164 Appendix E