Apple Macintosh LC 630 DOS - Manual (Page 165)

Closing the computer
1 Slip the base of the logic board into the guide rails inside the computer case and swing
the handle back into its storage position.
2 Press the reset button on the logic board, and then slide the logic board back into the
computer.
1 Press the reset button located on the main logic board
(the bottom-most layer) with a ball-point pen or similar object.
2 Gently but firmly
push the vertical plate
back into the computer
until the logic board is
solidly in place.
Make sure the logic board slides
into the guides that are on both
sides of the computer’s interior.
Swing the handle up,
into its storage position.
154 Appendix B