Campbell Scientific RTMC Pro Real-Time Monitor and Control Professional Software - Manual (Page 54)

RTMC Pro
4.2.1 Creating Websites
r
ton to publish the content.
To create a website, press the Add button and select either Add PC Website o
Add Datalogger Website. Fill in the settings as described below. After filling in
the desired settings, press the Publish Website but
Web Server Settings
Host Address - Specifies the address where you will be publishing your
colon followed by the port. For example,
campbellsci.com:8080, 192.168.1.1:1234, or
es will
vision history on our
website to determine when IPv6 support is added to the OS.)
Root User ID - In order to publish a website, a root-level user must be created.
The CSI Web Server Administrator is used to do this for the CSI Web Server.
Device Configuration Utility (DevConfig) is used to do this for a datalogger
web server. The .csipasswd file that is created controls user accounts and
passwords that will be able to publish projects to the web server. In order to
publish, a user account needs to be assigned an access level of “all”. This user
website. The address can be a domain name or IP address in the form
XXX.XXX.XXX.XXX for an IPv4 address or
[XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX] for an IPv6
address. If you are using a port other than the default port 80, you need to
specify it using a
[2620:24:8080:8600:85a1:fcf2:2172:11bf]:8080. (Note that IPv6 address
not be supported in dataloggers, until a future OS release for the
CR1000/CR3000/CR800 series dataloggers. Therefore, they cannot be used
for datalogger websites until that time. Check the OS re
48