High Country Tek emc-3L - Manual (Page 42)

Universal and Analog Inputs
Name Description Range
Name Get 0 to 100% regardless of direction 0% to 100%
NameLo Get 0 to 100% of Min to (Center -
Deadband) only if Center is enabled 0% to 100%
NameHi 1 Get 0 to 100% of (Center + Deadband)
to Max only if Center is enabled 0% to 100%
Name.Dir Get the Upper or Lower Side of the
Analog Input only if Center is enabled. False (Lower Side), True (Upper Side)
Name.RawVolts Volts or mAmps (ma = universal input
ma select) 0 to 1023 * Scale
†
Name.RefVolts Reference Volts = RefVolts * .00489 0 to 1023
Name.RampVolts Ramped Volts = RampVolts * Scale
Factor 0 to 1023 * Scale
†
Name.MinVolts When Name = 0% (i.e. Center not
enabled) 0 to 1023 * Scale †
Name.MaxVolts When Name = 100% 0 to 1023 * Scale
†
Name.MinLimit Threshold for Name.MinF 0 to 1023 * Scale
†
Name.MaxLimit Threshold for Name.MaxF 0 to 1023 * Scale †
Name.RefMinLimit Threshold for Name.MinRF 0 to 1023 * Scale
†
Name.RefMaxLimit Threshold for Name.MaxRF 0 to 1023 * Scale
†
Name.CenterVolts Where Center Volts 0 to 1023 * Scale
†
Name.Deadbandv Plus and minus volts about CenterVolts 0 to 1023 * Scale
†
NameX Where NameX = NameLo, NameHi if
Center is enabled NameX = Name if
Center is not enabled
Name.MinF Status Flag set if Voltage is less than
Min Limit False (ok), True (Outside Limit)
Name.MaxF Status Flag set if Voltage is greater than
Max Limit Range: False (ok), True (Outside Limit)
Name.MinRF Status Flag set if Voltage is less than
Reference Min Limit False (ok), True (Outside Limit)
Name.MaxRF Status Flag set if Voltage is greater than
Reference Max Limit False (ok), True (Outside Limit)
Name.LOS Loss of Signal flag set after time out.
For Universal Pulse inputs Only False (Pulses ok), True (No Pulse
Input)
Name.RealRPM The Unsigned Integer Value of the RPM.
For Universal Pulse inputs Only 0 to 9999
Name.Counter Get/Set Unsigned Integer Value of the
Counter. Universal Pulse inputs Only 0 to 65535
Name.PulsesPerRev Get/Set Pulses Per Revolution 0 to 9999
† Scale depends on Input Range (0 to 5 =.00489, 0 to 10 = .00977, 0 to 25ma = 0.02158 )
P/N: 021-00163, Rev. A.0 - for V5.2 Tools Page | 42