DAVIS Vantage Pro Console - Manual (Page 33)

Current Weather Mode
Calibrating Barometric Pressure
Note: Before calibrating the barometric pressure, be sure the station is set to the correct elevation.
1. Press BAR to select barometric pressure.
2. Press and release 2ND, then press and hold SET.
The pressure variable will blink.
3. Continue holding the key until the ticker reads “set barometer...”.
4. Press < or > to select digits in the variable.
5. Press + and - to add to or subtract from the digit’s value.
6. When you are finished, press DONE to exit calibration.
Setting Weather Variables
To set a weather variable’s value:
1. Select the variable you wish to change.
2. Press and release 2ND, then press and hold SET.
The variable will blink.
3. Keep holding the key until all digits are lit and only one digit is blinking.
4. Press < or > to select digits in the value.
5. Press + and - to add to or subtract from the selected digit.
6. When you are finished, press DONE to exit.
You can set values for the following weather variables:
Daily rain
This sets the daily rain total. Monthly and yearly rain totals are updated.
Monthly rain
This sets the current months total rain. Does not affect yearly rain total.
Yearly rain
The sets the current year’s rain total.
Daily ET
This sets the daily ET total. Monthly and yearly ET totals are updated.
Monthly ET
This sets the current month’s ET. Does not affect yearly total.
Yearly ET
This sets the current year’s total ET.