DAVIS Vantage Pro Console - Manual (Page 24)

3. Using Your Weather Station
Clear All Command
After you have completed the above setup procedures and have exited the
Setup Mode, please use the Clear All command before putting your weather
station into service.
Note: The Clear All command clears all stored high and low weather data including monthly and
yearly highs and lows and clears the alarm settings.
1. Press the WIND key on the console.
2. Press the 2ND key, then press and hold the CLEAR key for at least six
seconds.
3. Release the CLEAR key when you see the following message displayed
at the bottom of the console’s screen: “CLEARING NOW”.
Current Weather Mode
The Current Weather Mode displays the current data readings from your sta-
tion, select units of measure, and also to calibrate, set or clear weather vari-
ables. You can see up to ten weather variables on the screen at the same
time, as well as the time and date, the moon and forecast icons, a forecast
or special message from your station, and a graph of the currently selected
variable. A few variables are always visible on the console screen while
most variables shared their location with one or more other variables. You
can select any variable not currently on the screen to display it.
Selecting Weather Variables
Select a weather variable to display it’s data on the screen if it isn’t already
visible or to graph the variable in the Current Weather Mode screen.
Weather variables are selected via the console command keys:
• If the variable is printed on a key, just press the key to select the
variable.
• If the variable is printed on the console housing, first press and
release the 2ND key, then quickly press the key below the variable to
select it.
Note: After pressing the 2ND key, the screen displays the 2ND icon for three
seconds. Command key secondary functions are enabled during this time. The
keys return to normal operation after the icon disappears.
• You can also select any variable currently displayed on the LCD
screen using the +, - , <, and > navigation keys. Push + to move up
the screen. Push - to move down the screen. Push < to move left and
push > to move right.
• The console places a graph icon on the screen to indicate
the currently selected variable.
2 ND