DAVIS Vantage Pro Console - Manual (Page 14)

2. Installing the Console
Wall Mounting
The console mounts to the wall using two keyholes located on the back of
the case.
To mount the console on a wall:
1. Use a ruler to mark two mounting hole positions on the wall 8 inches (203
mm) apart.
If you are installing a standard Vantage Pro console with sensor cable
running inside the wall, mount the console over an empty switch box.
2. Use an drill a 3/32 or 7/64” (2.5 mm) drill bit to drill two pilot holes for the
screws.
3. Using a screwdriver, drive the two #6 x 1” pan head self-threading screws
into the wall. Leave at least 1/8” (3 mm) between the wall the heads of the
screws.
4. If the kickstand has been pulled out from the case, push it back into its
upright and locked position.
5. Guide the two keyholes on the back of the console over the two screw
heads.
Drill two 3/32" or 7/64" (2.4 to 2.8mm) holes
8" (203mm) apart for the #6 x 1" mounting screws.
8" (203mm)
Note: Drawing not to scale.
Wall Mounting the
Console