DAVIS Vantage Pro Console - Manual (Page 26)

3. Using Your Weather Station
Humidity
Press the HUM key to select outside humidity. Pressing the
HUM key a second time selects inside humidity. Humidity is
displayed in percent relative humidity.
Wind Chill
Press the 2ND key then press the CHILL key to select
Wind Chill. Wind Chill is displayed in either degrees
Fahrenheit (ºF) or Centigrade (ºC).
Note: The console uses the ten-minute average wind speed to calculate wind chill.
Dew Point
Press the 2ND key then press the DEW PT key to
select Dew Point. Dew Point is displayed in either
degrees Fahrenheit (ºF) or Centigrade (ºC).
Barometric Pressure
Press the BAR key to select barometric pressure. Baromet-
ric pressure may be displayed in inches (in), millimeters
(mm), millibars (mb) or hectoPascals (hPa).
Pressure Trend
The pressure trend arrow indicates the current barometric trend,
measured over the last 3 hours. The pressure trend requires three
hours of data in order to be calculated so you won’t see it right away
on a new station. The pressure trend is always indicated on the console
screen, as long as required data is available.
N
W
NE
SE SW
Vertical Scale: X10
WIND
RAIN YEAR
in
TEMP OUT
HUM IN
HUM OUT
DAILY RAIN
in
TEMP IN
hPa
BAROMETER
STATION NO.1
F
F
F
MPH
Last 24 hrs hr Every 1
S
E
NW pm
HEAT INDEX
HUM OUT HUM IN
CHILL
F
DEW POINT
F
hPa
BAROMETER
Humidity, Pressure, Dew Point, & Wind
Chill
DEW PT
HUM
CHILL
WIND 2 ND
DEW PT
HUM 2 ND
ET
BAR