Backend commands, Changing the login password, Setting the hub’s ip address via the command line – AMX UDM-0102 User Manual
Page 74
Advanced Administration
62
UDM-0102 and UDM-RX02 Operation/Reference Guide
Backend Commands
In case of human error the Command Line can be used to perform several Administrative tasks on the
UDM-0102.
Changing the Login Password
1.
Create a hyperterminal session with the UDM hub using default serial connections.
2.
To change the password enter the original password and new password separated by a full colon at
the login prompt.
For example type in admin:endeleo at the login prompt, to change the password from admin to
endeleo.
3.
Reset the Hub. A power off then on is now required.
Obtaining the Hub’s IP Address Via the Command Line
1.
Type i at the command prompt (FIG. 84).
2.
Push Enter.
Setting the Hub’s IP Address Via the Command Line
1.
Type i
2.
Push Enter.
FIG. 84
Issuing the i command