AMX UDM-0102 - Manual (Page 72)

Advanced Administration
60 UDM-0102 and UDM-RX02 Operation/Reference Guide
5. Push Enter to execute the command.
6. The command window can be closed.
Copying the Hub Configuration file
Copying the Hub Configuration file permits the Administrator to backup key data entered by
Administrators such as Input names, Port names, Devices and the Hub setup.
To backup the Hub Configuration file;
1. Run the TFTP client.
2. Start a command session on the PC. Change to the directory where the Hub Configuration file is to
be stored on the PC e.g. cd\hub.
3. Type in the following command at the prompt observing the parameters below;
tftp –i [IP address] get hxxxxx.hub
Where hxxxxxx.hub is the name of the hub configuration file.
If the name of the Hub Configuration file is not known, typing in h followed by xxx will find the
file, as there is only one file beginning with "h" in the UDM-0102.
FIG. 83 Issuing tftp commands to the UDM-RX02 via the Hub
Ensure the tftp client has been installed on the PC which will be used to send files to
the hub. Install tftp client if necessary, consult with Endeleo support as to the
appropriate client.