AMX AVS-SL-PR-0401-0601 - Manual

Installation Guide
Solecis
AVS-SL-PR-0401-0601
Overview
The Solecis AVS-SL-PR-0401-0601 Presentation Switcher (FG1330-2011-01) combines
switching of PC, computer, video and audio for presentation and conference rooms, home
cinema, AV Rental Companies and any environment where a number of mixed source types
need to be displayed.The AVS-SL-PR-0401-0601 features a total of 10 inputs and a
programmable serial output for controlling projectors, plasma displays and other display
devices.
Product Specifications
Connections
Typical Installation for Use With a Projector
Connect the RGB, Video and Audio sources to the Input sockets on the rear panel of the unit.
The RGB/Video inputs are 75 ohm terminated and the audio inputs 47Kohm terminated.
The RGB/Video and audio outputs are fully 75 ohm and 600 ohm driven respectively for
connection to long cable runs. It is imperative that the input sources are fully compatible with
the display and sound devices.
Video
• There are 4 PC inputs and 6 video inputs.
• 2 outputs are available for PC and 2 outputs for Composite Video and S-video.
• Video Inputs may be either Composite Video, S-Video, or a combination of both.
Note: Since the switcher now auto-senses between the Composite and S-Video inputs, the
dip switches have no effect unless you are using the Device Serial Output. If you are using
the Device Serial Output, dip switches 1 to 6 must be set to match the incoming source type
on their corresponding inputs. The projector or display device should be switched to match
the Source type output. If you are using the serial output, it is also necessary to configure the
unit with Solecis DCS. Consult the Solecis DCS Quick Start Guide for more information.
Audio
One unbalanced output is available on Phono (RCA) connectors and one balanced output is
available on phoenix connectors.
Power
Connect a Mains Source (110 to 240V) to the AVS-SL-PR-0401-0601.
• The Blank Button will illuminate.
• If any Source is connected to Inputs 1 of the PC and Video groups then Sync only will
be present on the output.
FIG. 1 Solecis AVS-SL-PR-0401-0601 Presentation Switcher
AVS-SL-PR-0401-0601 Specifications
RGB Inputs
Number 4
Connector HD-15
Level: Analog
Max Level: 1V p-p
Impedance: 75 ohm
Bandwidth 250MHz -3dB
Return Loss -38dB@10MHz, -20dB@100MHz
Adjacent Input Crosstalk -80dB@10MHz, -70dB@100MHz
Sync Input
Type: Analog or TTL
Max Level: 5V p-p
Impedance: 75 ohm
Video Input
Number 6
Connectors Phono/RCA/Captive-wire 4Pin Din S-Video
Type YC or Composite
Level: Analog
Max Input: 1V P-P
Impedance: 75 Ohm
Bandwidth 50MHz -3dB
Return Loss: -30dB@1MHz, -22dB@5MHz
Differential Phase Error 0.05%
Differential Gain Error 0.03%
Crosstalk -60dB@1MHz
Audio Input
Number 10
Connectors Phono/RCA
Type Stereo Unbalanced Analog
Max Level 2V P-P
(front)
(rear)
COMPUTER
VIDEO Input Select pushbuttons VOLUME Up/Down
BLANK On/Off pushbutton
AUDIO MUTE status LED
AUDIO BREAKAWAY status LED
Input Select pushbuttons
pushbuttons
Power status LED
Video Audio
Video Source Select
RS-232 Serial Output
Outputs Computer
Inputs 1-4
1-2
Computer/Audio
Inputs 1-4
Inputs 1-6
AUDIO OUT
L/R
Video Inputs 1-6
Video Outputs 1-2
DIP Switch
Power Cord input
AVS-SL-PR-0401-0601 Specifications (Cont.)
Audio Input (Cont.)
Impedance 47K
Audio Response 20-50 KHz
RGB Output
Number: 2
Connector: HD-15
Level: Analog
Gain: Unity
Sync
Impedance: 75 ohm
Sync Level: TTL
Sync Impedance: 75 ohm
Video Output
Number 2
Type YC or Composite
Connectors Phono/RCA/Captive-wire 4Pin Din S-Video
Level: Analog
Gain: Unity
Audio Output
Number 2
Connector Captive-wire
Type Stereo Unbalanced and Balanced Analog
Attenuation: 0 to -78dB
Impedance 600 Ohm
Control
Type: RS232 Send and Receive, Front Panel
Connector: Captive-Wire
Protocol: Baud Rate-9600, Data Bits-8, No Parity, Stop Bits-1
Address: 00 – FF software programmable
Input: RS232
Serial Output: Programmable Protocol
Type: Power On/Off, RGB Input, Composite Input and YC Input
Audio Breakaway: Available through RS232 command
Power: • 110 to 240V auto-switching
• Power Connector: IEC
Dimensions: 2U Rack Mounting x 160mm
Weight: 4.22 lb (1.916 kg)
Included Accessories: • IEC Mains Lead
• Programming Software (available from amx.com)
Certifications: • CE
• UL60950
• FCC class B, part 15
• RoHS/WEEE compliant