HP 3000 Enterprise Virtual Array - Manual (Page 94)

Figure 38 Removing a power supply
Installing a power supply
1. Lift up on the module latch (1, Figure 39 ) and slide the power supply into the enclosure until it is
fully seated.
2. Connect the power cord to the power supply and engage the cord lock.
Figure 39 Installing a power supply
Verifying proper operation
After replacing the power supply or blower, check the following to verify that the component is operating
properly:
NOTE:
It may take up to 10 minutes for the component to display good status.
• Make sure the blower begins operating immediately.
• The status indicator should be on.
94 Customer replaceable units