beautypg.com

Adding a disk drive, Removing the drive blank, 6 sequential building of vertical disk groups – HP 3000 Enterprise Virtual Array User Manual

Page 39: Figure 6

background image

NOTE:

Standard and FATA disk drives must be in separate disk groups. Disk drives of different capacities and

spindle speeds can be included in the same disk group, but you may want to consider separating

them into separate disk groups.

CX8167-ST

2

1

Figure 6 Sequential building of vertical disk groups

1. Disks installed in first group
2. Disks installed in second group

Adding a disk drive

This section describes the procedure for adding a Fibre Channel disk drive.

Removing the drive blank

1.

Grasp the drive blank by the two mounting tabs (see

Figure 7

).

2.

Lift up on the lower mounting tab and pull the blank out of the enclosure.

Enterprise Virtual Array 3000/5000 user guide

39