HP 3000 Enterprise Virtual Array - Manual (Page 71)

NOTE:
To exit any menu, press Esc or wait ten seconds for the OCP display to return to the default display.
Table 25 identifies the menu options available within the OCP display.
CAUTION:
Some of the configuration settings available through the OCP impact the operating characteristics of
the storage system. You should not change any setting unless you understand how it will impact system
operation. For more information on the OCP settings, contact your HP-authorized service representative.
Table 25 Menu options within the OCP display
Information Fault Management Shutdown Options System Password
Port Config Last Fault Restart Change Password
UUID Unique Half Detail View Power Off Clear Password
Controller Versions System Uninitialize Current Password
Debug Flags
Unbypass Loops
Print Flags
Displaying system information
NOTE:
The purpose of this information is to assist the HP-authorized service representative when servicing
your system.
The system information displays show the system configuration including the VCS version, the OCP
firmware and application programming interface (API) versions, and the enclosure address bus
programmable integrated circuit (PIC) configuration. You can only view, not change, this information.
Displaying versions system information
When you press , the active display is Versions. From the Versions display you can determine the:
• OCP firmware version
• Controller version
• VCS version
NOTE:
The terms PPC, Sprite, Glue, SDC, CBIC, and Atlantis are for development purposes and have no
significance for normal operation.
NOTE:
When viewing the software or firmware version information, pressing displays the Versions Menu tree.
To display System Information
Enterprise Virtual Array 3000/5000 user guide 71