HP XP20000XP24000 Disk Array - Manual (Page 71)

Preparing for Cross-OS File Exchange Operations 3-15
Hitachi USP V Cross-OS File Exchange User’s Guide
Installing the FAL/FCU Software
The FAL/FCU software must be installed on the UNIX/NT server(s) attached to
the subsystem. FAL/FCU software installation for the UNIX-based platforms is
different from FAL/FCU installation on Windows 2000/2003/Windows NT. The
following sections provide instructions for installing FAL/FCU version 01-01-
36/38 or later. For instructions on installing versions 01-01-24 and earlier,
please refer to previous revisions of this document.
Installing FAL/FCU on UNIX-Based Platforms
32-Bit FAL/FCU Software
To install the 32-bit FAL/FCU software on a UNIX-based platform:
1. If FAL/FCU version 01-01-36 or later is already installed (by cpio command),
you do not need to uninstall it. A new installation will overwrite the previous
version.
If FAL/FCU version 01-01-24 or earlier is already installed (by setup
program), you must uninstall this older version as follows before installing
version 01-01-36 or later:
a) Log in with the same user ID that was used to install the old FAL/FCU
software.
b) If FAL/FCU was installed from FD using the setup program, see
Uninstallation to remove FAL/FCU.
c) If FAL/FCU was installed from DAT, or if you can’t find your FAL/FCU
installation FD, move to the directory fcu/fal.o/dataset.h and remove
FAL/FCU by entering:
# rm fcu fal.o dataset.h $HOME/FcuMf
If you cannot find the directory, you can use the following procedure:
# find / -name “fcu” -print
# find / -name “fal.o” -print
# find / -name “dataset.h” -print
# find / -name “FcuMf” -print
2. Log in to the system as root.
3. Insert the FAL/FCU installation media (e.g., CD-ROM) into the drive.
Note: Verify that the device file for the CD-ROM drive exists. For Solaris,
do not use volcheck if the CD-ROM device file is not available for auto-
mount.