HP XP20000XP24000 Disk Array - Manual (Page 196)

7-8 Troubleshooting
Hitachi USP V Cross-OS File Exchange User’s Guide
Error
Code Error Message and Description Recommended Action(s)
-109 Parameter file: DELIMITER error
The delimiter option specified in
the parameter definition file is not
valid.
Make sure that the delimiter is specified as either CR, LF, or
No.
-110* Parameter file: Open error
An error occurred when opening
and outputting the parameter
definition file.
Display the system error code using the Help-Error
command. Please refer to the OS user manual for
information on system errors.
-111 Parameter file: Write error
An error occurred when writing to
the parameter definition file.
Display the system error code using the Help-Error
command. Please refer to the OS user manual for
information on system errors.
-112 Parameter file: Close error
An error occurred when closing
the parameter definition file.
Display the system error code using the Help-Error
command. Please refer to the OS user manual for
information on system errors.
-114 Parameter: No input file name
The input file name was not
specified.
Make sure to specify the input file name.
-115 Parameter: VSN error
The specified VSN is not correct.
Make sure that the specified VSN matches the actual VSN.
Make sure that the VSN is separated from the dataset name
by a colon (:).
-116 Parameter: Input file name error
The specified input file name is
not correct.
Make sure that the specified file name matches the actual file
name.
-117 Parameter: Dataset name error
The specified input dataset name
is not correct.
Make sure that the specified dataset name matches the
actual dataset name.
-118 Parameter: Output file name error
The specified output file name is
incorrect.
Make sure that the specified output file name matches the
actual output file name.
-119* Input file: Open error
An error occurred when acquiring
the dataset attribute information
of the input file.
Display the error code using the Help-Error command. If an
FAL error code is displayed, refer to Table C.1. If a system
error code is displayed, please refer to the OS user manual.
For example, if a partition name does not match the partition
name in the volume definition file, system error code 6 (No
such device) is displayed.
-120 Overwrite ? (OK/Cancel)
This message asks you to confirm
whether to overwrite the existing
file.
The specified open-system target file already exists. Select
OK to overwrite the file, or select Cancel to specify a
different target file.
-121 Output file: File name error
The output file name is not
specified.
Make sure that the correct output file name is specified.
-122* Output file: Open error
An OPEN error occurred when
checking to see if the output file
exists.
Display the system error code using the Help-Error
command. Please refer to the OS user manual for
information on system errors.