HP XP20000XP24000 Disk Array - Manual (Page 191)

Troubleshooting 7-3
Hitachi USP V Cross-OS File Exchange User’s Guide
Error Codes and Messages
The error information returned by the datasetGetLastError function includes
the FAL error information defined in the dataset.h file. Table 7-2 lists and
describes the FAL error codes and provides instructions for resolving each
error condition. In Table 7-2, the error codes marked by an asterisk (*) may
also be reported when I/O access contention occurs. If the cause of the error
cannot be identified as described in Table 7-2, check for illegal I/O access
contention for the FX volume between the z/OS and open-system hosts.
The FAL error logs for UNIX are /tmp/fal_error and /tmp/fal_error.bak,
and /tmp/fal_dump and /tmp/fal_dump.bak. The FAL logs for Windows
2000/2003/Windows NT systems are c:\fal_error and c:\fal_error.bak, and
c:\fal_dump and c:\fal_dump.bak.
Note: Error codes with a negative value are FAL errors. Error codes with a
positive value are system errors. UNIX system error codes are defined in the
standard error file errno.h.
Table 7-2 FAL Error Codes
Error
Code Error Message and Description Recommended Action(s)
-7* DATASET_ERROR_INVALID_VOLUME
The actual VSN and the VSN specified in the FX
volume definition file do not match.
Make sure that the VSN in the FX volume
definition file is correct.
-8 DATASET_ERROR_DATASET_NOT_FOUND
The target dataset was not found.
Make sure that the actual dataset name and the
specified dataset name are the same. You can
use the MF-File list command in the FCU HELP
menu, or VTOC dump data on the z/OS host, to
check the dataset name.
-9 DATASET_ERROR_NOT_SUPPORTED
The data format is not supported.
Make sure that the dataset was created correctly
on the z/OS host.
-10* DATASET_ERROR_DEVICE_TYPE_NOT_SUPPORTED
The device emulation type is not supported.
Make sure that the device emulation type (LVI)
is correct in the FX volume definition file. The
supported LVIs are 3390-3A, -3B and -3C.
-11 DATASET_ERROR_DSORG_NOT_SUPPORTED
The dataset organization type is not supported.
Check the DO type using the MF-File list
command in the FCU HELP menu, or VTOC
dump data on the z/OS host.
-12 DATASET_ERROR_RECFM_NOT_SUPPORTED
The record format is not supported.
Check the RF type using the MF-File list
command in the FCU HELP menu, or VTOC
dump data on the z/OS host.
-13* DATASET_ERROR_INVALID_DATA
The data in the VTOC or the dataset is invalid.
Make sure that the VTOC and dataset were
created correctly on the z/OS host.
-14* DATASET_ERROR_VOLUME_DEFINITION_INVALID
The format of volume definition file is invalid.
Make sure that the FX volume definition file was
created correctly.
-15 DATASET_ERROR_DATASET_NOT_OPENED
An attempt was made to read the dataset without
opening it.
Make sure that the datasetOpen function is
called before the datasetGet function.