HP XP20000XP24000 Disk Array - Manual (Page 204)

7-16 Troubleshooting
Hitachi USP V Cross-OS File Exchange User’s Guide
FCU Error Codes for Windows Systems
If FCU for Windows 2000/2003/Windows NT systems reports an error, use the
View-Error information… command to view the most recent error. FCU for
Windows 2000/2003/Windows NT systems also logs errors in the FCU log file
(e.g., fcudata.prm.log). Table 7-4 lists and describes the FCU error codes for
Windows 2000/Windows NT systems and provides instructions for resolving
each error condition.
Note: Error codes with a plus value are system errors. Windows
2000/2003/Windows NT
systems system error codes are defined in the
errno.h file attached with Microsoft Visual C++ ® .
Table 7-4 FCU Error Codes for Windows 2000/2003/Windows NT Systems
Error
Code Error Message and Description Recommended Action(s)
-100 Parameter definition file: Open error
An error occurred when opening the
parameter definition file.
Make sure that the parameter definition file was created
correctly. If the parameter definition file was created
correctly, check the system error.
-101 Parameter: Count error
An error is detected in the parameter count. Make sure that the parameter count is correct.
-102 Parameter: Direction error
The data transfer direction is not correct. Make sure that the direction is specified correctly as mto
or otm.
-103 Parameter: Mainframe file name error
Mainframe file name is not correct. Make sure that the mainframe file name is set correctly.
-104 Parameter: Open system file name error
Open system file name is not correct. Make sure that the open system file name is set correctly.
-105 Parameter: Code conversion error
Code conversion setting is not correct. Make sure that the code conversion option is specified as
EA, EcA, No, or File_name (of your code conversion
table). This error may also be reported if you mix
3390/3380 and OPEN-x devices in the same FX volume
definition file.
-106 Parameter: Padding error
Padding setting is not correct. Make sure that the padding option is specified as Yes or
No.
-107 Parameter: Delimiter error
Delimiter setting is not correct. Make sure that the delimiter option is specified as CRLF or
No.
-108 Parameter: Add parameter error
Delimiter setting is not correct. If you are adding delimiters for Windows
2000/2003/Windows NT systems, make sure that the
delimiter option is specified as CRLF (not just CR or LF).
-109 Parameter: Empty duplication error
More than one empty setting is specified. Specify only one empty setting.
-110 Parameter: RDW duplication error
More than one RDW setting is specified. Specify only one RDW setting.
-120 Volume definition file: Open error
An error is detected when opening the volume definition
file.
Make sure that the volume definition file was created
correctly. If the volume definition file is correct, check the
system error.