HP XP P9500 Storage - Manual (Page 80)

Figure 24 Configuration example for which logical volumes cannot be identified only by characteristic
Oracle StorEdge 6120/6320
When connecting a Oracle StorEdge 6120/6320 as an external storage system, set the system
parameters of the Oracle StorEdge 6120/6320 according to the following table. For the system
parameters that are not in the following table, see the documentation of the Oracle StorEdge
6120/6320 and set the parameters appropriately for the connecting configuration.
Table 24 System parameter (connecting Oracle StorEdge 6120/6320)
Parameter setting Parameter
SUN port host
Oracle StorageTek FlexLine 380
When you connect a Oracle StorageTek FlexLine 380 as an external storage system, set the system
parameters of the Oracle StorageTek FlexLine 380 according to the following table. For the system
parameters that are not in the following table, see the documentation of the Oracle StorageTek
FlexLine 380 and set the parameters appropriately for the connecting configuration.
Table 25 System parameter (Oracle StorageTek FlexLine 380)
Parameter setting Parameter
Windows Non-clustered (DMP Support) host type
Oracle StorageTek 2540
When connecting an Oracle StorageTek 2540 as an external storage system, set the system
parameters of the Oracle StorageTek 2540 according to the following table. For the system
parameters that are not in the following table, see the documentation of the Oracle StorageTek
2540 and set the parameters appropriately for the connecting configuration.
Table 26 System parameter (Oracle StorageTek 2540)
Parameter setting Parameter
Windows 2K non Clustered DMP host type
Oracle StorageTek V2X2
When connecting Oracle StorageTek V2X2 as an external storage system, make sure that only
one external path is configured when you map external volumes. Do not add any alternate paths
after you finish mapping external volumes.
80 Connecting external storage systems