HP XP RAID Manager Software - Manual (Page 47)

3. Enter the message in the window.
Alphanumeric characters and symbols can be used in the message. The maximum length of
the message is 2,048.
4. Click Apply.
Setting e-mail notification for SIMs or SNMP traps
You can specify notification by email to key users when system failures occur. Failures reported in
the e-mail are the same as the SIMs displayed in the Alerts window or reported by SNMP traps.
•
You can configure e-mails for any SIMs caused by software licensing events or Thin Provisioning
threshold events.
•
With SNMP traps, e-mail notification eliminates the need for checking for failures in SNMP
manager.
You can also send a test e-mail.
SIMs failures reported by e-mail typically require user action. These SIMs are caused either by
reaching the trigger levels configured by the user, or by a software license needing user attention.
The following SIMs are reported by e-mail:
Table 12 SIM reference codes reported by e-mail
Alert level Description Reference code
SIM13 SIM23 SIM22
SERIOUS License key Expiration xx F7 7F
SERIOUS Exceeded the licensed capacity xx F8 7F
SERIOUS Program product invalidated by the expiration of the
prerequisite program product xx F9 7F
MODERATE Failure with
paired volumes Exceeded the pool usage threshold xx 00 60
MODERATE Snapshot Pool Pool blockade xx 2x 60
MODERATE Thin Provisioning
Pool Exceeded the pool usage warning threshold xx 0x 62
MODERATE Exceeded the pool usage system threshold xx 1x 62
MODERATE Pool became full. xx 2x 62
MODERATE Exceeded the pool usage depletion threshold xx 6x 62
MODERATE Exceeded the Thin Provisioning volume usage
threshold xx 0x 63
Configuring e-mail notification
Prerequisites
•
You must have the Storage Administrator (Initial Configuration) role to perform this task.
•
You must have a mail server that supports the Simple Mail Transfer Protocol (SMTP).
•
If a firewall is used, port 25 must be used.
Procedure 29 To configure settings for e-mail notice:
1. Click Settings > Environmental Setting > E-mail Information. The E-mail Information window
opens.
2. Click to change to Modify mode.
3. Select Enable in Mail Notice.
Setting e-mail notification for SIMs or SNMP traps 47