HP XP RAID Manager Software - Manual (Page 168)

Use the E-mail Information window to configure settings to report storage system failures (SIMs)
by e-mail. You can also send a test e-mail from this window.
Description Item
Specify whether to report system failures by e-mail. Mail Notice
•
Enable: Reports system failures by e-mail.
• Disable: Does not report system failures by e-mail.
Set an IPv4 address, an IPv6 address, or a host name of the mail server. Mail Server
•
To set an IPv4 address, select IPv4 and enter four integers in the range of 0 to 255 (for
example, nnn.nnn.nnn.nnn, where n is a number).
•
To set an IPv6 address, select IPv6 and enter eight hexadecimal numbers in the range of 0
to FFFF (for example, hhhh:hhhh:hhhh:hhhh:hhhh:hhhh:hhhh:hhhh, where h is a
hexadecimal digit). Enter 0 to omit a segment.
•
To set a host name, select Host Name and enter up to 63 alphanumeric characters (ASCII
codes) and symbols, except for the following symbols and a space:
" \ ; : , * ? < > | / # & + = [ ] ' { } ^
Specify whether to use SMTP authentication. SMTP-AUTH
• Enable: Uses SMTP authentication.
•
Disable: Does not use SMTP authentication.
Set the account and password for SMTP authentication. Required when SMTP-AUTH is Enable.
Enter up to 255 alphanumeric characters and symbols (ASCII codes) for user ID and password,
except for the following symbols and a space: Account and
Password
" \ ; : , * ? < > | / # & + = [ ] ' { } ^
Specify an e-mail address of the sender. Enter up to 255 alphanumeric characters (ASCII codes)
and symbols ( ! # $ % & ` + - * / ' ^ { } _ . ). From Address
Specify a Reply-To address of e-mail. If you specify this address, replies from the e-mail receivers
will be sent to this address. If you omit this address, replies from the e-mail receivers will be sent
to From Address. The available values are the same as those of From Address. Return Address
Specify e-mail addresses of the receivers and the attributes (To, Cc, or Bcc). Up to 32 addresses
can be specified. The available values are the same as those of From Address. To Address
When you click Test Send, test e-mails are sent to the e-mail addresses of the receivers. This
button is available only in Modify mode. Test Send
Implements all the settings. This button is available only in Modify mode. Apply
Cancels all the settings. This button is available only in Modify mode. Cancel
168 Remote Web Console GUI reference (secondary windows)