HP Color LaserJet 8550 Multifunction Printer series - Manual (Page 51)

50 2 Using the Printer Control Panel EN
Selecting the Display Language
Using the printer control panel, you can set the printer to display
printer messages and print test pages in a variety of supported
languages.
To select the display language
1 Hold down S ELECT while turning the printer off and then on.
CONFIG LANGUAGE (in English) appears on the printer control
panel display for approximately one second. Once the printer has
restarted,
LANGUAGE=ENGLISH will appear.
Note Only -V ALUE + , S ELECT , and G O are active while the display language
is being configured. All other keys are ignored.
If you press G O without selecting a language, the printer will bring
itself online and all subsequent messages will be displayed in
English. However, since no display language was selected, the
LANGUAGE=ENGLISH message will reappear (after the power-on self
test) when the printer is next turned on. This message will be
displayed every time the printer is turned on until you select a
language through the configure language mode.
2 Press -V ALUE + until the language you want appears on the
display.
3 Press S ELECT to save the selection. An asterisk ( * ) appears to the
right of the selection. The language selected will be the default
language until another selection is made by restarting the printer
in the configure language mode.
4 Press G O to bring the printer online.