HP Color LaserJet 8550 Multifunction Printer series User Manual
Page 178

EN
Printer Response Problems 177
(The printer is on, but not
receiving data (Data light
does not blink and
nothing prints),
continued)
If you are using AppleTalk, verify that the AppleTalk
name matches the name on the configuration page.
Print the configuration page. Go to the Chooser menu.
Select the printer type. In the list box, select the printer
name that matches the printer name on the
configuration page. Select the printer port icon. When
you close the Chooser menu, the settings will be saved.
The printer is on and
receiving data (Data light
blinks), but nothing prints
READY
is not displayed on the printer control panel.
Press
G
O
to bring the printer online.
The levers inside the front door of the printer might not
be latched. Verify all levers inside the front door are
properly latched and close the front door.
The Data indicator is flashing. Wait for the Data
indicator to stop flashing. The printer is still receiving
data.
The printer might be out of toner. Check the printer
control panel display for
TONER OUT REPLACE
.
For more information on replacing the toner cartridge,
see the installation guide included with the toner
cartridge.
The imaging drum life might be exceeded. Check the
printer control panel display for
DRUM LIFE OUT
REPLACE DRUM KIT
. For more information on replacing
the drum kit, see the installation guide included with the
drum kit.
Check the printer control panel for messages. For more
information on resolving printer control panel
messages, see chapter
.”
The parallel port might have an MS-DOS timeout error.
Add a MODE command to the autoexec.bat file. For
example, in MS-DOS 4.0 or later, use
MODE LPT1: B
.
For earlier versions of MS-DOS, use
MODE LPT1: P
.
Both examples are for a printer connected to LPT1. See
the MS-DOS documentation for more information.
Problem
Cause and Solution