HP Color LaserJet 8550 Multifunction Printer series User Manual
Page 136
EN
Printer Messages 135
56.2 ERROR
CYCLE POWER
Indicates an illegal output
error. For example, the
multi-bin mailbox is not
installed and it was selected
as the output destination, or
there are transparencies in
the duplexer.
Open the printer and remove
media from the paper path.
Verify that the media type is
set in the printer control panel.
Turn the printer off and on to
reset the printer. If the
condition persists, contact a
local authorized HP dealer or
service representative for
service. For more information
on configuring input trays, see
“
” in chapter
.
57.X FAN FAILURE
One of the cooling fans has
failed.
X = Fan Type
1 = Rear Output Fan
(Motor 1)
2 = Rear Input Fan (Motor 2)
3 = Left Output Fan (Motor 3)
Turn the printer off and then
on to reset the printer. If the
message reappears, contact a
local authorized HP dealer or
service representative for
service. Do not operate the
printer in this condition or
the printer can be seriously
damaged.
58.1 ERROR
CYCLE POWER
Indicates that the paper
diverter inside the upper right
door is out of position,
causing an error feeding
media from tray 1.
Open the upper right door and
check for a media jam or
misfed media. Turn the printer
off and on to reset the printer.
If the message reappears,
contact a local authorized HP
dealer or service
representative for service.
59.X MOTOR ERROR
CYCLE POWER
Indicates that the main printer
motor is not working properly.
X = Description
0 = General Error
1 = Startup Error
2 = Rotation Error
Turn the printer off and on to
reset the printer. If the
condition persists, contact a
local authorized HP dealer or
service representative for
service.
Message
Description
Recommended Action