HP Designjet Z6100 Printer series - Manual (Page 55)

NOTE: If you want to move the printer, first remove the take-up reel sensor and cable housing
unit from the foot of the printer stand. Place the sensor and cable housing unit on the printer stand
crossbar and use the blue plastic screw to affix the housing unit to the leg of the stand, as shown,
while the printer is being moved. When reinstalling the housing unit, make sure that the wheel on
the foot of the printer stand is pointing forward.
Unload a roll from the take-up reel
1
.
On the printer's front panel, select the icon, and then select Paper unload > Unload roll.
The printer advances the paper to allow for cutting.
2
. Lift the take-up reel deflector to its upright position.
3
. Switch the wind-direction switch to the Off position. The switch is in the off position when it is centered
(in other words, when the switch is neither in position 1 nor position 2).
Use the take-up reel 43
H
a
ndle the paper