HP Designjet Z6100 Printer series User Manual

Page 54

Carefully insert the loop-shaping core.

NOTE:

Make sure that you insert the loop-shaping core. The take-up reel will not function

correctly without it. The loop-shaping core must have end caps. Make sure that the end caps

extend over the edges of the paper.

Use the wind-direction switch on the take-up reel motor to select the winding direction. Setting 1

winds the paper so that the printed image faces in. Setting 2 winds the paper so that the printed

image faces out.

The front panel shows you to the correct setting based on the winding-direction decision you made

in step 7.

Press the OK button on the front panel. The Take-up reel has been successfully installed

message appears.

The following image shows how the printer looks when it is operating. As paper is fed from the

printer, it drops down in a loop and then up into the take-up reel spindle.

NOTE:

While the take-up reel is operating, make sure that the take-up reel sensors are not

blocked.

NOTE:

The automatic paper-cutter is disabled when the take-up reel is in use.

42 Chapter 4 Handle the paper

Handle the paper