HP Integrity NonStop H-Series - Manual (Page 43)

Operating the 5258ACL Tape Drive
5258ACL Installation and User’s Guide — 522345-001
3- 15
Show History
An underlined cursor appears underneath the first digit. To set the first digit, press the #
or ! scroll button until the desired code number appears. To move the cursor to the
second digit, press Enter. Repeat the process for each of the four digits. Remember to
copy the 4-digit number; you will need it to enter the Menu mode. An unlock code of
0000 disables control panel locking.
Press Escape; the screen shown in Figure 3-17 appears. The specific unit code is shown
in place of XXXX.
Figure 3-17. Code Accept Submenu
Press Enter when the unlock code that appears is acceptable. Press Escape if it is not
acceptable. Press Escape again to return to the Main menu, and again to return to the
Default screen.
Unlocking the Control Panel
After the control panel is locked through the Security menu, you are asked to enter the
security code to enter the Menu mode. The security code entry screen shown in
Figure 3-18 appears.
Figure 3-18. Panel Locked Screen
When Enter is pressed, the screen in Figure 3-19 appears.
Figure 3-19. Code Entry Submenu
Scroll to set the first digit of the unlock code. Press Enter to move the cursor to the
second digit and repeat the process. When the entire unlock code has been entered, press
Note. The control panel lock also prevents operator access to the Unlock Door selection on
the Main menu. For a detailed discussion of magazine locking, see
Removing the Magazine on
page 3-18 and Inserting a Magazine Into the 5258ACL on page 3-18 later in this section.
Even while the control panel is locked, the Status menu can still be displayed without using the
security code by pressing Escape at the Default screen
Unlock Code
*”XXXX”
ENTER to Accept
ESCAPE to Exit
Front Panel Locked
ENTER to Unlock
ESCAPE to Exit
U n l o c k C o d e % % % %
“ “
# # # #