HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 47)

Domain management 47
System Log Configuration
Use this screen to view or set remote log destination settings.
Column Description
Log host The IP address or the DNS of the configured remote log destination
Log severity Severity of the log messages that should be sent to the specified destination. Valid
values include "Critical", "Error", "Warning", and "Informational".
Transport The transport protocol to be used for sending the log messages to the destination.
Valid values include "TCP" and "UDP".
Port The port to be used on the destination to send the log messages. Valid values
include 1 to 65536. The default value is 514.
Security Secure transmission of the log messages. Valid values include "None" and
"STunnel". The default value is "None", and no encryption is used during
transmission.
The "STunnel" option can be used only if the transport protocol used is TCP.
Date Format The timestamp format for the log messages. Valid values include "RFC3164" (Nov
26 13:15:55) and "ISO8601" (1997-07-16T19:20:30+01:00). The default value is
"RFC3164".
Enabled Enables or disables the remote log destination
To define a new remote log destination, click Define Target.
To send a test message to all enabled remote log destinations, click Test.