Domain settings (domain enclosures), Adding and importing a remote enclosure – HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem User Manual
Page 26

Domain management 26
The following table describes the available actions in the Domain Settings (Domain IP Address) screen.
Clicking another link in the pull-down menu or left navigation window causes current edits that have not
been applied to be lost.
Task Action
Use a domain IP address
Select the box next to Use Domain IP address, and then enter the IP
Address, Subnet Mask, and Gateway.
Clear unsaved changes on the screen
Click Clear.
Save changes and remain on this screen Click Apply.
Cancel without saving changes
Click Cancel.
Domain Settings (Domain Enclosures)
Use this screen to import, delete, or add enclosures in the domain.
Multiple enclosures are supported only if a 1/10Gb-F VC-Enet module or Flex-10 module is running in
bay 1 and bay 2 of the primary enclosure.
For additional information on adding and importing a remote enclosure and connecting multiple
enclosures, see the HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide.
- 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem 4GB Virtual Connect Fibre Channel Module for c-Class BladeSystem Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem