HP StorageWorks 1510i Modular Smart Array - Manual (Page 66)

Enabling iSNS discovery of specific targets (Discovery Settings)
1. Select Target > Discovery Settings.
2. Expand the drop-down boxes to Enable SLP and/or iSNS Discovery.
Identifying devices (Identify Device)
To locate a system component by lighting up its LEDs, select the item from the component list, and then
select Identify Device.
For example, if this task is selected for a logical drive, the LEDs on the physical hard drives included
in that logical drive are illuminated.
Refreshing the display (Refresh System)
Use this option to update the SMU display.
To refresh the SMU display, select Refresh System. The utility scans the configuration and, after a few
moments, updates the display.
Resetting the system (Reset System)
Use this option to remotely reset (power cycle) the array controller.
To reset the array controller, select Storage System > Reset System.
The following warning message is displayed.
66 Configure